Yamaha digital mixing studio 01x User Manual

01X   Owner’s Manual

You can use the following operation to send audio buses to 

specific mLAN output pairs.  For example, you can direct 

the two Aux Out pairs (AUX 1/2, AUX 3/4) to separate 

mLAN outputs.  You can route the stereo bus and the 

record bus (REC Bus) to independent mLAN outputs from 

this page as well.  Keep in mind, this all happens digitally 

over the high-speed IEEE 1394 (Firewire/i.Link) connec-

tion, letting you directly feed digital audio to an mLAN-

equipped device.  For more information about mLAN and 

related applications, see page 22 and the separate Installa-

tion Guide.

■ Operation

q Make sure your computer (mLAN device) is properly 

connected to the 01X and configured for operation.

For details on using mLAN, see page 66 and the sepa-

rate Installation Guide.

w Call up the Utility mode by pressing the [UTILITY] 

button.

e Press knob 2 to call up the Patch parameters.

r Select page 5 with the DISPLAY [ / ] (Up/Down) 

buttons.

Page 5 contains four Output Patch sources: Stereo Bus, 

Recording Bus, Aux Bus 1/2, and Aux Bus 3/4.

t Use the even numbered knobs to change the mLAN 

output channel pair for each audio bus.

For example, to send the Aux 1/2 signals to mLAN 

channels 9 and 10, turn knob 6 until “9/10” is selected 

for the Aux 1/2 settting.

If desired, save this setting also to the Output Patch 

Library for future recall.  (See page 91.)

Once you create a Patch setup, you’ll probably want to 

save it for future use.  That’s what the Input and Output 

Patch Libraries are for.  They let you store your custom 

Input and Output settings, so that the next time you have a 

same or similar recording situation, you can appropriately 

reconfigure the entire console with just a few button 

presses.

■ Operation

q Call up the Utility mode by pressing the [UTILITY] 

button.

w Press knob 2 to call up the Patch parameters.

e Use the DISPLAY [ / ] (Up/Down) buttons to select 

the Library page.

The Input Patch Library is on Page 4, while the Output 

Patch Library is on Page 8.

r Use knob 1 to select the desired Library preset number.

t Press STORE (knob 6) followed by YES (knob 8) to 

save the settings to the selected number. 

y Name your new Library preset.

For details on naming, see page 41.

UTILITY

OUTPUT PATCH (mLAN OUT CHANNEL)

5/8

ST-BUS≥[1/2 ] RECBUS≥[3/4 ] AUX1/2≥[5/6 ] AUX3/4≥[7/8 ]

Stereo 
Bus

mLAN destination pair

Recording 
Bus

Aux Bus 
3/4

Aux Bus 
1/2

UTILITY

OUTPUT PATCH (mLAN OUT CHANNEL)

5/8

ST-BUS≥[1/2 ] RECBUS≥[3/4 ] AUX1/2≥[9/10] AUX3/4≥[7/8 ]

UTILITY

INPUT PATCH LIBRARY

4/8

*

00 [Initial Data

]

RECALL/STORE /CLEAR