Yamaha htr-5890 User Manual

“LEARN” and the selected component name (ex. 
“DVD”) appear alternately in the display window.

• Do not press and hold LEARN. If you hold it down for 

more than 3 seconds, the remote enters the remote control 
code setting mode.

• If you do not complete each of the following steps within 

30 seconds, the learning mode will be automatically 
canceled. In this case, press LEARN again.

“LEARN” appears in the display window.

“NG” appears in the display window if learning was 
unsuccessful. In this case, start over from step 5.

y

• If you want to program another function, repeat steps 5 

and 6.

• If you continuously want to program another function for 

another component, press the input selector button or 
SELECT k/n to select the component, then repeat steps 3 
through 6.

• “ERROR” appears in the display window if you press a button 

not indicated in the respective step, or when you press more 
than one button simultaneously.

• This remote control can learn approximately 200 functions. 

However, depending on the signals learned, “FULL” may 
appear in the display before you program 200 functions. In this 
case, clear unnecessary programmed functions to make room 
for further learning.

• Learning may not be possible in the following cases:

– When the batteries in the remote control for this unit or other 

components are weak.

– When the distance between the two remote controls is too 

great or too small.

– When the remote control infrared windows are not facing 

each other at the appropriate angle.

– When the remote control is exposed to direct sunlight.
– When the function to be programmed is continuous or 

uncommon.

LEARN

LEARN

01EN00_HTR5890U.book  Page 69  Thursday, December 23, 2004  12:39 PM