Yamaha HTR-5930 User Manual

Use the remote control to access and adjust each 
parameter.

y

• You can change the “SET MENU” parameters while this unit is 

reproducing sound.

• You can use NEXT (A/B/C/D/E) and SET MENU +/– 

(PRESET/TUNING/CH l / h) on the front panel to change 
these settings, if “TUNER” is not selected as the input source. 
Press NEXT to select the category or field you wish to change, 
and SET MENU +/– to change the parameters.

Press SET MENU repeatedly to display the 
desired menu and then press i to enter the 
menu.

y

Once you press SET MENU, you can also select the menu 
by pressing u / d.

Press u / d repeatedly to select the item and 
then press j / i to change the parameter.
Depending on the menu item, press u / d to select a 
sub item, and then press j / i to change the parameter.

To exit, press u / d repeatedly until the 
menu disappears.

Use this menu to manually adjust any speaker settings.

• If you select “SETUP” (see page 20) and then select “SET” 

after adjusting the “SOUND MENU” parameters, the “SETUP” 
parameters override the “SOUND MENU” parameters. Do not 
enter “SETUP” unless you wish to change the “SOUND 
MENU” parameters. If you accidentally enter “SETUP”, select 
“CANCEL” to exit from “SETUP”.

• Some menu item settings have no effect when the unit is 

reproducing a source with a digital signal sampling frequency 
greater than 48 kHz.

■ Speaker settings

 1 SPEAKER SET

Use this feature to manually adjust any speaker setting.

y

If you are not satisfied with the bass sounds from your speakers, 
you can change these settings according to your preference.

1A CENTER

Choices: LRG (large), SML (small), NON (none)
• Select “LRG” if you have a large center speaker. The 

entire range of the center channel signals is directed to 
the center speaker.

• Select “SML” if you have a small center speaker. The 

low-frequency signals of the center channel are 
directed to the speakers selected with “1D BASS”.

• Select “NON” if you do not have a center speaker. The 

entire range of the center channel signals is directed to 
the front left and right speakers.

1B FRONT

Choices: LRG (large), SML (small)

• Select “SML” if you have small front speakers. The 

low-frequency signals of the front channel are directed 
to the speakers selected with “1D BASS”.

• Select “LRG” if you have large front speakers. The 

entire range of the front left and right channel signals is 
directed to the front left and right speakers.