Yamaha RX-V1900BL User Manual

 

y

The wire of the AM loop antenna does not have any polarity 
and you can connect either end of the wire to AM or GND 
terminal.

■ Connecting the AC power cable

Plug the supplied AC power cable into the AC inlet after 
all other connections are complete, then plug the AC 
power cable into an AC wall outlet.

(Asia model only) Select one of the supplied power cables 
suitable for the type of AC wall outlet in your location before 
plugging this unit into the AC wall outlet.

■ AC OUTLET(S) (SWITCHED)

U.K. and Australia models ..................................... 1 outlet
Korea model ............................................................... None
Other models ......................................................... 2 outlets

Use these outlet(s) to supply power to any connected 
components. Connect the power cable of your other 
components to these outlet(s). Power to these outlet(s) is 
supplied when this unit is turned on. However, power to 
these outlet(s) is cut off when this unit is turned off. For 
information on the maximum power or the total power 
consumption of the components that can be connected to 
these outlet(s), see “Specifications” (page 121).

Memory back-up
The memory back-up circuit prevents the stored data 
from being lost even if this unit is in the standby mode. 
However, the stored data will be lost in case the power 
cable is disconnected from the AC wall outlet or if the 
power supply is cut off for more than one week.