Manualsbrain.com
  1. Manuals
  2. Brands
  3. Yamaha
  4. RX-V1900BL
  5. User Manual

Yamaha RX-V1900BL User Manual

Download
Page of 146
26
 En
Connections
1
Make sure this unit is turned off.
2
Press and hold O
STRAIGHT on the front 
panel and then press A
MASTER ON/OFF 
inward to the ON position.
This unit turns on, and the advanced setup menu 
appears in the front panel display.
3
Rotate the N
PROGRAM selector to select 
“SPEAKER IMP.”.
4
Press O
STRAIGHT repeatedly to select 
“6
Ω MIN”.
5
Press A
MASTER ON/OFF to release it 
outward to the OFF position to save the new 
setting and turn off this unit.
The setting you made is reflected next time you turn on this 
unit.
■ Turning on this unit
Press A
MASTER ON/OFF on the front panel 
inward to the ON position.
When you turn on this unit by pressing AMASTER ON/
OFF, the main zone is turned on.
■ Turning off this unit
Press A
MASTER ON/OFF on the front panel 
again to release it outward to the OFF position.
■ Set the main zone to the standby mode
Press B
MAIN ZONE ON/OFF 
(or C
STANDBY).
■ Turning on the main zone from the 
standby mode
Press B
MAIN ZONE ON/OFF (or DPOWER).
y
• Basically, we recommend that you use the standby mode to turn 
off this unit. In the standby mode, this unit consumes a small 
amount of power in order to receive infrared signals from the 
remote control.
•
BMAIN ZONE ON/OFF, CSTANDBY and DPOWER are 
operational only when 
AMASTER ON/OFF is pressed inward 
to the ON position.
• When you turn on this unit, there will be a delay for a few 
seconds before this unit can reproduce sound.
Setting the speaker impedance
Caution
If you are to use 6 ohm speakers, set “SPEAKER 
IMP.” to “6
Ω MIN” as follows BEFORE using this 
unit. You can also use 4 ohm speakers as the front 
speakers (page 102).
Note
EFFECT
STRAIGHT
MASTER
While holding 
down
Turning this unit on and off
If there are some problems...
• First, turn off and then turn on this unit again.
• If problems persist, initialize the parameters of this