Yamaha RX-V1900BL User Manual

Select the Bluetooth receiver in the 
Bluetooth device list and then enter the pass 
key “0000” on the Bluetooth component. 
Once this unit completes the pairing successfully, 
“Completed” appears.

y

To cancel the pairing, press 9RETURN.

Press 9

RETURN to exit from “START 

• If the connected Bluetooth receiver cannot find any Bluetooth 

components, “Not found” appears.

• If a Bluetooth receiver is not connected to this unit, “No 

Bluetooth receiver” appears.

INPUT CH

Use this setting to select the number of channels input 
from an external decoder (page 23).

FRONT

If you set “INPUT CH” to “8CH”, you need to specify the 
analog audio jacks at which the front left and right channel 
signals output from the connected external decoder are 
input.
Choices: CD, TV, MD/CD-R, BD/HD DVD, DVD, CBL/

SAT, DVR, VCR, V-AUX

“FRONT” is available only when “INPUT CH” is set to “8CH”.

Use this menu to adjust the optional system parameters.

■ Display settings

A)DISPLAY SET

You can reset the “OSD SHIFT” and “GRAY BACK” settings 
to the initial factory settings by using “VIDEO” of 
“INITIALIZE” in “ADVANCED SETUP” (page 103).

DIMMER

Use this feature to adjust the brightness of the front panel 
display.
Control range: – 4 to 0
Control step: 1
• To make the front panel display dimmer, press 8l.
• To make the front panel display brighter, press 8h.

OSD SHIFT

Use this feature to adjust the vertical position of the OSD.
Control range: –5 (downward) to +5 (upward)
Control step: 1
Initial setting: 0
• To lower the position of the OSD, press 8l.
• To raise the position of the OSD, press 8h.

GRAY BACK

Use this feature to display a gray background in your 
video monitor when there is no video signal being input.

Depending on the video signals being input or the system 
setting of your video monitor (NTSC or PAL), the OSD may be 
displayed abnormally. In such cases, set “GRAY BACK” to 
“OFF”.

Select this setting if the connected component 
outputs discrete 6-channel audio signals.

8ch

Select this setting if the connected component 
outputs discrete 8-channel audio signals. You 
also need to configure the “FRONT” setting 
(below).

Displays a gray background on your video 
monitor when there is no video signal being 
input.

OFF

Does not display a gray background on your 
video monitor.