Yamaha RX-N600 User Manual

CONNECTIONS

PREP

ARA

TION

Both FM and AM indoor antennas are supplied with this
unit. In general, these antennas should provide sufficient
signal strength. Connect each antenna correctly to the
designated terminals.

• Be sure to set the tuner frequency step (General model only)

according to the frequency spacing in your area (see page 92).

• The AM loop antenna should be placed away from this unit.
• The AM loop antenna should always be connected, even if an

outdoor AM antenna is connected to this unit.

• A properly installed outdoor antenna provides clearer reception

than an indoor one. If you experience poor reception quality,
install an outdoor antenna. Consult the nearest authorized
YAMAHA dealer or service center about outdoor antennas.

■

Connecting the AM loop antenna

Set up the AM loop antenna.

Press and hold the tab of the AM ANT
terminal.

Insert one of the AM loop antenna lead wires
into the AM ANT terminal.

Release the tab of the AM ANT terminal back
into place.

Repeat steps 2 through 4 to connect the
other lead wire to the GND terminal.

Once you have properly connected the AM loop antenna to this
unit, orient the AM loop antenna for the best reception when you
tune into AM stations.

Connecting the FM and AM antennas

Notes

FM ANT

UNBAL.

ANT

GND

TUNER

AM loop antenna
(supplied)

Ground (GND terminal)

For maximum safety and
minimum interference,
connect the antenna GND
terminal to a good earth
ground. A good earth ground
is a metal stake driven into
moist earth.

Indoor FM antenna
(supplied)

Outdoor AM antenna

Use a 5 to 10 m (16 to 32 ft) of vinyl-
covered wire extended from a
window.