Yamaha RX-N600 User Manual
26
En
CONNECTIONS
Once all connections are complete, plug the power cable into the AC wall outlet.
■
VOLTAGE SELECTOR
(General model only)
(General model only)
The VOLTAGE SELECTOR on the rear panel of
this unit must be set for your local voltage
BEFORE plugging the power cable into the AC
wall outlet. Improper setting of the VOLTAGE
SELECTOR may cause damage to this unit and
create a potential fire hazard.
this unit must be set for your local voltage
BEFORE plugging the power cable into the AC
wall outlet. Improper setting of the VOLTAGE
SELECTOR may cause damage to this unit and
create a potential fire hazard.
Rotate the VOLTAGE SELECTOR clockwise or
counterclockwise to the correct position using a
straight slot screwdriver.
counterclockwise to the correct position using a
straight slot screwdriver.
Voltages are 110/120/220/230–240 V AC, 50/60 Hz.
■
AC OUTLET(S) (SWITCHED)
Australia model...................................................... 1 outlet
Korea model............................................................... None
Other models......................................................... 2 outlets
Korea model............................................................... None
Other models......................................................... 2 outlets
Use these outlet(s) to supply power to any connected
components. Connect the power cable of your other
components to these outlet(s). Power to these outlet(s) is
supplied when the main zone or Zone 2 is turned on.
However, power to these outlet(s) is cut off when both the
main zone and Zone 2 are turned off or when MASTER
ON/OFF on the front panel is pressed and released
outward to the OFF position. For information on the
maximum power or the total power consumption of the
components that can be connected to these outlet(s), see
“SPECIFICATIONS” on page 119.
components. Connect the power cable of your other
components to these outlet(s). Power to these outlet(s) is
supplied when the main zone or Zone 2 is turned on.
However, power to these outlet(s) is cut off when both the
main zone and Zone 2 are turned off or when MASTER
ON/OFF on the front panel is pressed and released
outward to the OFF position. For information on the
maximum power or the total power consumption of the
components that can be connected to these outlet(s), see
“SPECIFICATIONS” on page 119.
Connecting the power cable
AC OUTLETS
To the AC wall outlet
(U.S.A. model)
CAUTION
230-
240V
VOLTAGE
SELECTOR
Voltage indication
Memory back-up
The memory back-up circuit prevents the stored data
from being lost even if this unit is in the standby mode.
However, the stored data will be lost in case the power
cable is disconnected from the AC wall outlet or if the
power supply is cut off for more than one week.
from being lost even if this unit is in the standby mode.
However, the stored data will be lost in case the power
cable is disconnected from the AC wall outlet or if the
power supply is cut off for more than one week.