Yamaha RX-V757 User Manual

The preset number, the MEMORY and AUTO 
indicators flash. After about 5 seconds, automatic 
presetting starts from the frequency currently 
displayed and proceeds toward the higher 
frequencies.

When automatic preset tuning is completed, the front 
panel display shows the frequency of the last preset 
station.

• Any stored station data existing under a preset number is 

cleared when you store a new station under that preset number.

• If the number of received stations does not reach 40 (E8), 

automatic preset tuning has automatically stopped after 
searching all stations.

• Only FM stations with sufficient signal strength are stored 

automatically by automatic preset tuning. If the station you 
want to store is weak in signal strength, tune into it manually, 
and store it by following the procedure in “Manually presetting 
stations”.

You can select the preset number from which this unit will 
store FM stations and/or begin tuning toward lower 
frequencies.
After pressing MEMORY in step 3:
1 Press A/B/C/D/E, then PRESET/TUNING/CH l / h 

to select the preset number under which the first station 
will be stored. Automatic preset tuning will stop when 
stations have all been stored up to E8.

2 Press PRESET/TUNING (EDIT) to turn off the colon 

(:) and then press PRESET/TUNING/CH l to begin 
tuning toward the lower frequencies.

■

You can also store up to 40 stations (8 stations in 5 groups, 
A1 through E8) manually.

See page 39 for tuning instructions.

When tuned into a station, the front panel display 
shows the frequency of the station received.

The MEMORY indicator flashes for about 5 seconds.

The group letter appears. Check that the colon (:) 
appears in the front panel display.

The memory back-up circuit prevents the stored data 
from being lost even if this unit is set in the standby 
mode, the power cord is disconnected from the AC 
outlet, or the power supply is temporarily cut due to 
power failure. However, if the power is cut for more 
than one week, the preset stations may be cleared. If 
so, store the stations again by using the presetting 
station methods.

l

h

MEMORY