SVAT Electronics CLEARVU3 User Manual

now you can see

CLEARVU3

13

You can use these settings to adjust the area and sensitivity of motion detection on each 

camera channel. These settings are important if you are using motion activated recording, 

because if adjusted correctly, they can help prevent false triggering of 

motion recording.

1.  Channel – Select the camera channel in which you would like to make changes

2.  Set Detection Area – Select this setting to enter a grid screen for the selected 

camera channel. In this screen you can set the areas in the camera’s view that 
you want to enable or block motion detection in. For example, if there are cars 

constantly driving by in an area on your camera, you can block that area from 

detecting motion. Use the directions below to set up motion detection areas:

• 

Grey: Detection Block. These areas will be detected

• 

Transparent: Non-Detection Block. 

• 

Green: Flashes when motion on the camera is being detected.

Use the green flashes to determine where motion is consistently being detected, and then 
make sure to set the motion detection area to exclude these areas from motion detection. 
Follow the directions below:

• 

Press “SEARCH” button to enable whole detection area. 

• 

Press “MENU” button to disable whole detection area. 

• 

You can set up a maximum of 3 separate detection areas (Detection areas  
may overlap):

• 

Press the” UP/ DOWN/ LEFT/ RIGHT” buttons to setup the starting point of the 
detection area.

• 

Press the “ENTER” button to confirm the starting point of the detection area.

• 

Press the “UP/ DOWN/ LEFT/ RIGHT” buttons to drag the window and set the 

ending point of the detection area. 

• 

Press the “ENTER” button to confirm the ending point of the detection area.