SMART Technologies board d600 User Manual

CHAPTER 2 – INSTALLING AND SECURING YOUR SMART BOARD 
INTERACTIVE WHITEBOARD

Aligning Your Interactive Whiteboard with Your Projector

If your projector is installed in a fixed location, align your interactive whiteboard 
to the projected image before you secure the L-shaped brackets. A correctly aligned 
image fits squarely on your interactive whiteboard’s screen. Each side of the projected 
image should extend almost to the edge of the display surface.

IMPORTANT
For SMART Board D600 series interactive whiteboards, it is important to align 
your interactive whiteboard and projector correctly so that the projected image 
divider in dual-user mode in SMART Notebook software aligns with the physical 
center of your interactive whiteboard. The actual divider will always be in the 
physical center of your interactive whiteboard, regardless of where your projected 
image falls.

1. Install or position your projector on a projector platform or stand if necessary, 

and then turn it on and point the lens of your projector at the center of your 
interactive whiteboard’s screen.

2. Make fine adjustments to the image size, level and focus of the projected image, 

following your projector manufacturer’s instructions.

3. Slide your interactive whiteboard sideways on its bracket to align it with the 

projected image.

4. Repeat steps 2 and 3 until your interactive whiteboard is properly aligned.

Completing Your Installation

Refer to the following procedure to finish installing your interactive whiteboard.

1. Below the bottom frame, you’ll 

find two L-shaped metal 
brackets. In the center of each 
bracket there is a metal tab. 
Push this tab back until it 
contacts the wall, and then 
mark the location of the 
mounting holes with 
your pencil.