SMART Technologies board d600 User Manual

CHAPTER 2 – INSTALLING AND SECURING YOUR SMART BOARD 
INTERACTIVE WHITEBOARD

Removing the Pen Tray

You might need to remove the pen tray when you transport or repair your interactive 
whiteboard. 

WARNING
There are no user-serviceable parts inside the pen tray. Only qualified personnel 
should disassemble the pen tray’s printed circuit boards, and this procedure must 
be done with proper electrostatic discharge (ESD) protection.

CAUTION
If dust or small items prevent the pen tray buttons from being pressed or cause 
constant button contact, remove the obstructions carefully.

NOTE
You don’t need to wear ESD protection when performing the following procedure.

1. Turn off your interactive whiteboard 

by disconnecting the USB cable to your 
computer or by disconnecting the expansion 
module’s power supply, as appropriate.

2. Remove the pens and the eraser from the 

pen tray.

3. Reach under the pen tray and disconnect 

the modular cable.

4. If you secured the pen tray to its brackets 

using two screws as described in the 
previous section, remove these screws.

5. If you secured the pen tray using a Kensington lock or similar device, unlock and 

remove the lock.

6. Reach under the pen tray and pull down on the two large plastic clips. Because 

the ends of these clips project slightly downward, they’re easy to locate.

7. While applying downward pressure to the clips, gently slide the pen tray toward 

you until it detaches from the two L-shaped metal brackets.