Sennheiser EM 3732 User Manual
31
The operating menu
왘
Change the setting to “Booster Feed On” or “Booster Feed Off” by
turning the jog dial
turning the jog dial
.
왘
Press the
save
button
The selected setting is stored. When the booster supply voltage is
switched on, the two LEDs
switched on, the two LEDs
light up. The display changes to
the selection mode of the operating menu.
Adjusting the audio output level
AF Out
Via the “
AF Out
” menu, you can adjust the maximum output level of the
audio outputs (AF out and Command).
With the EM 3732 Command, the audio level of the Command output 1
L
corresponds to the level of the audio output 1
M
and the audio level of the
Command output 2
J
corresponds to the level of the audio output 2
K
.
The following figures are a guide to the best settings:
y Line input level:
y Line input level:
+5
to
+18 dB
y Microphone input level:
–10
to
+4 dB
To obtain the best signal-to-noise ration, adjust the respective maximum
audio level to the settings shown above.
audio level to the settings shown above.
왘
Change to the setting mode of the “
AF Out
” menu.
The current setting starts flashing.
왘
Adjust the audio output level by turning the jog dial
.
The display shows the selected audio output level.
왘
Press the
save
button
The selected setting is stored. The display changes to the selection
mode of the operating menu.
mode of the operating menu.
Selecting the sampling rate for digitalization
Clock
Via the “
Clock
” menu, you can select the sampling rate with which the
analog signal is digitalized and output via the digital balanced XLR-3M
audio output
audio output
. You can choose between the sampling rates “44.1 kHz”,
“48 kHz”, “88.2 kHz”, “96 kHz” and “Ext.”. “Ext.” means that the receiver
will use one of above sampling rates from the external word clock
generator. In this case, you first have to connect an external word clock
generator to the BNC socket
will use one of above sampling rates from the external word clock
generator. In this case, you first have to connect an external word clock
generator to the BNC socket
generator” on page 18) and switch it on.
왘
Change to the setting mode of the “
Clock
” menu.
The current setting starts flashing.
왘
Select the desired sampling rate by turning the jog dial
왘
Press the
save
button
The selected sampling rate is stored. The display changes to the
selection mode of the operating menu.
selection mode of the operating menu.
Note:
If you select “Ext.” even though no external word clock signal is
available at the BNC socket for word clock input
available at the BNC socket for word clock input
(e.g. because the
esc
s
ave
syn
c
digital audio
processing
syn
c
DEV
M
H
z
790.800
03.03
BANK
CH
COM
AF
+12
+12 dB
esc
s
ave
syn
c
digital audio
processing
syn
c
DEV
M
H
z
790.800
03.03
BANK
CH
COM
AF
48
44.1
48
88.2
96
Ext.
48
88.2
96
Ext.
kHz
esc
s
ave
syn
c
digital audio
processing
syn
c
DEV
M
H
z
790.800
03.03
BANK
CH
COM
AF