SMSC LAN9311 User Manual

Two Port 10/100 Managed Ethernet Switch with 16-Bit Non-PCI CPU Interface

Revision 1.4 (08-19-08)

110

SMSC LAN9311/LAN9311i

 

In this mode only A[2:1] are decoded, and any burst read of the LAN9311/LAN9311i will read the RX
Data FIFO. This mode is enabled when FIFO_SEL is driven high during a read access. This is normally
accomplished by connecting the FIFO_SEL signal to a high-order address line. This mode is useful
when the host processor must increment its address when accessing the LAN9311/LAN9311i. Timing
is identical to a PIO burst read, and the FIFO_SEL and END_SEL signals have the same timing
characteristics as the address lines.

In this mode, performance is improved by allowing an unlimited number of back-to-back WORD read
cycles. RX Data FIFO direct PIO burst reads can be performed using chip select (nCS) or read enable
(nRD). An RX Data FIFO direct PIO burst read begins when both nCS and nRD are asserted. Either
or both of these control signals must de-assert between bursts for the period specified in 

. The burst cycle ends when

either or both nCS and nRD are de-asserted. They may be asserted and de-asserted in any order.
Read data is valid as indicated in the functional timing diagram in 

A[1] must toggle during burst reads. Fresh data is supplied each time A[1] is toggled.

Please refer to 

 for

the AC timing specifications for PIO RX Data FIFO direct PIO burst read operations.

END_SEL

A[x:3]

A[2:1]

nCS, nRD

D[15:0] (OUTPUT)

FIFO_SEL

(READ DATA FROM RX DATA FIFO)