Seagate barracuda 4lp st32171n-w-wc-wd-dc User Manual
Barracuda 4LP Installation Guide, Rev. B
17
Initial setup information
The general information beginning on this page applies to all of
the Barracuda 4LP drive models. After reading the general infor-
mation topics, refer to the appropriate drive-specific section
listed below for additional information about configuring and
installing your particular model.
the Barracuda 4LP drive models. After reading the general infor-
mation topics, refer to the appropriate drive-specific section
listed below for additional information about configuring and
installing your particular model.
Drive models
Page
ST32171N
ST32271N
ST34371N
ST34571N
ST32171W/WD
ST32271W/WD
ST34371W/WD
ST34571W/WD
ST32171WC/DC
ST32271WC/DC
ST34371WC/DC
ST34571WC/DC
General information
The following general information topics are discussed:
• SCSI ID jumpers
• Drive termination
• Terminator power
• Interface drivers and data path width notes
• Other applicable jumper options
• Providing adequate cooling
• Mounting the drive and connecting cables
• Drive termination
• Terminator power
• Interface drivers and data path width notes
• Other applicable jumper options
• Providing adequate cooling
• Mounting the drive and connecting cables
1
• Formatting the drive
1
This mounting procedure does not apply to “WC” or “DC” model
drives. To mount a “WC” or “DC” drive, plug the drive into the
system’s single connector attachment (SCA) position on the
system’s back panel.
system’s single connector attachment (SCA) position on the
system’s back panel.