Adam Equipment 302666242 User Manual
© Adam Equipment Company 2011
Page
36
Press the [U.Wt/Unit] to go to next
menu. Press [Print] to enter.
Use [U.Wt/Unit] to select the
decimal point position and press
[Print].
To change the remote scale cap
press CE to clear and then enter
new value followed by [Print].
menu. Press [Print] to enter.
Use [U.Wt/Unit] to select the
decimal point position and press
[Print].
To change the remote scale cap
press CE to clear and then enter
new value followed by [Print].
“
CAP
”. Scale capacity setting.
“dESC” “ 0.00”
“LOAd” “0060”
Press [U.Wt/Unit] to go to next
menu. Press [Print] to enter.
Use [U.Wt/Unit] to select the
division which you would like the
display to increment in, followed by
[Print].
menu. Press [Print] to enter.
Use [U.Wt/Unit] to select the
division which you would like the
display to increment in, followed by
[Print].
“inC 5”
Press the [U.Wt/Unit] to go to next
menu, use [Print] key to enter.
Use [U.Wt/Unit] to increment the
values then [Print].
menu, use [Print] key to enter.
Use [U.Wt/Unit] to increment the
values then [Print].
“AZt”
Autozero tracking range.
Select from
0.5d
0.5d
0.5d
0.5d, 1d, 2d, 4,d
Press the [U.Wt/Unit] to go to next
menu, use [Print] key to enter.
Use [U.Wt/Unit] to increment the
values then [Print].
menu, use [Print] key to enter.
Use [U.Wt/Unit] to increment the
values then [Print].
“0 Auto”
Zero auto range at
power on.
Select from
Select from
0%, to 10%
Press the [U.Wt/Unit] to go to next
menu, use [Print] key to enter.
Use [U.Wt/Unit] to increment the
values then [Print].
menu, use [Print] key to enter.
Use [U.Wt/Unit] to increment the
values then [Print].
“0
manl
” Zero manual range.
Select from
0%, to 10%
Press the [U.Wt/Unit] to go to next
menu, use [Print] key to enter.
Enter the new PIN number and
press [Print].
Confirm the new PIN number and
press [Print].
menu, use [Print] key to enter.
Enter the new PIN number and
press [Print].
Confirm the new PIN number and
press [Print].
“
Pin
” Password number for “
tEch
”.
“Pin1”
“Pin2”
“donE”
“Pin2”
“donE”
Press [U.Wt./Units] to continue
use [Print] key to enter.
Escape the parameters with the
[Zero/Tare]
use [Print] key to enter.
Escape the parameters with the
[Zero/Tare]
“
CAL
” Enter calibration section
where the local or remote scale is
selected. See section 10.
selected. See section 10.