Sun Microsystems enterprise server 220r User Manual
92
Sun Enterprise 220R Server Owner’s Guide • October 1999
How to Remove a Disk Drive
The system’s disk hot-plug feature lets you remove a disk drive without shutting
down the operating system or turning off the system power. For more
information, see:
down the operating system or turning off the system power. For more
information, see:
■
“About Disk Array Configurations and Concepts” on page 70
■
“About Internal Disk Drives” on page 74
Before You Begin
You must follow antistatic precautions when handling a disk drive. For more
information, see:
information, see:
■
If the server is set up without a local graphics console, terminal, or monitor, you
need to set up one of these options in order to issue software commands. See “Howto Attach an Alphanumeric (ASCII) Terminal” on page 29, “How to Configure aLocal Graphics Console” on page 31, or “About Communicating With the Server” onpage 28.
need to set up one of these options in order to issue software commands. See “Howto Attach an Alphanumeric (ASCII) Terminal” on page 29, “How to Configure aLocal Graphics Console” on page 31, or “About Communicating With the Server” onpage 28.
What to Do
1. Prepare the system for disk removal.
The hot-plug removal procedure involves software commands for preparing the
system prior to removing the disk drive. See “About Internal Disk Drives” onpage 74.
system prior to removing the disk drive. See “About Internal Disk Drives” onpage 74.
2. If you are not hot-plugging the disk drive, halt the operating system and turn off
the system power.
3. Unlock the front doors and swing them open.
Turn the keyswitch to the Power-On/Off position. This unlocks the system front
doors.
doors.
4. Identify the disk drive to be removed and note the bay in which it is installed.
The lower bay is the default system disk location. For information about disk status
LEDs, see “About Internal Disk Drives” on page 74.
LEDs, see “About Internal Disk Drives” on page 74.