Adam Equipment ae-301 User Manual
© Adam Equipment Company November 2011
8
3.7 ALARM
3.7.1 Over-load alarming
•
When the sample weight on the scale is over the maximum
capacity the beep will sound and the display will show “Err“.
•
Remove the weight immediately to avoid any damage to the scale.
3.7.2 Low-load alarming
•
If the top pan is not placed on the scale the beep will sound.
•
Place the top pan on the scale before starting to weigh.
3.7.3 Low battery alarming
•
When
appears on the LCD, re-charge the battery.
•
During re-charging, the symbol will show four bars.
•
If this symbol appears, re-charge the battery immediately to avoid
any damage to the battery.
4.0 USER PARAMETERS
The following parameters can be set by the user by entering the function
setting mode. Press the [Tare] key while switching on the indicator. The
first parameter will be displayed along with the settings done previously.
setting mode. Press the [Tare] key while switching on the indicator. The
first parameter will be displayed along with the settings done previously.
•
The available parameters can be cycled through by pressing
the [Mode] key.
•
Not all parameters may be enabled. Some parameters may
be set during the initial configuration and the user is not
given access to them. In this case those will not be seen
when the [Mode] key is pressed. To use any of the
parameters see the corresponding section of the manual.
given access to them. In this case those will not be seen
when the [Mode] key is pressed. To use any of the
parameters see the corresponding section of the manual.
•
Switch off and switch on again to return to weighing when
settings are complete.