Adam Equipment cbw 30 User Manual

 

•  Before beginning, tare the weight of any container that will be 

used, leaving the empty container on the scale. 

 

•  For CBW- 6H /12aH, place the sample first and then press the 

 For all other models first press the [Func] key to 

begin.  The scale will show "P 10" asking for a sample size of 10 
parts.  Change the sample size by pressing the [Tare/Ï] key.  
The display will cycle through the options: 10, 20, 50, 100, 200 
and back to 10.  

 

•  Place the number of samples on the scale.  The number should 

match the options for parts counting, i.e., 10, 20, 50, 100 or 200 
pieces.   

 

• Press the [Zero/Enter] key when the number matches the 

number of parts used for the sample.  As more weight is added, 
the display will show the number of parts (pcs).  

 

• Press the [%] key to display unit weight (g/pcs or lb/pcs), Total 

weight (kg or lb) or the count (pcs). 

 

 

• Press [Func] to return to normal weighing.  

 

•  ‘lb’ will be shown on the CBWa scales when weighing unit is set 

to pounds. 

 
 

 

Check-weighing is a procedure to cause an alarm to sound when the 
weight on the scale meets or exceeds the values stored in memory.  
The memory holds values for a high limit and a low limit.  Either or both 
the limits can be used. 
 
NOTE:

 The alarm can be set to OFF (See the section 7.7 on 

Parameter). In this case the display will indicate whenever the weight is 
within or exceeds the limits by showing ‘OK’, ‘HI’ or ‘LO’. 

10