Adtran MX2800 M13 User Manual
2-8
61200290L1-1G
Section 2, Installation and Operation
MX2800 M13 Multiplexer User Manual
NOTE
DSX-3 interfaces must be connected using coaxial cables that have the
shields grounded at both ends.
shields grounded at both ends.
DSX-1/E1 Interfaces
The DSX-1/E1 interfaces are 64-pin amphenol connectors. These interfaces provide Tx and Rx
connections between the unit and equipment such as wire-wrap patch panels, punch-down panels, or
breakout panels.
connections between the unit and equipment such as wire-wrap patch panels, punch-down panels, or
breakout panels.
NOTE
Connect the DSX-1/E1 interfaces to intra-building wiring only.
Power Connection
The DC power connections are described in
7. FRONT PANEL
The MX2800 front panel is shown in
. Descriptions of each part of the front panel follow:
•
•
•
•
•
Figure 2-4. MX2800 Front Panel
Craft Port
The craft port, an 8-pin modular jack, provides connection to a VT100 EIA-232 compatible interface
(using the supplied 8-pin modular to DB-9 female connector and the 8-pin to 8-pin modular cable).
(using the supplied 8-pin modular to DB-9 female connector and the 8-pin to 8-pin modular cable).
A
C
T
C
T
N
E
T
E
T
A
L
L
M
P
R
F
R
F