Adam Equipment azplus 6 User Manual
6.2 USING “2003” TO ENTER THE SERVICE PARAMETERS
After the jumper has been placed in position K6, apply power to the scale.
During the self-test press the [Tare] key.
The display will ask for a code number, “
Pn - - - -
“ on the Weight Display.
Enter the number 2003 when “
Pn - - - -
“ is displayed and then press [Tare].
The displays will show the first parameters, called “
F1
”. To select another parameter press
the [PLU4] key to advance through the parameters.
Press the [Tare] key to enter a parameter.
To exit a parameter press the [Zero] key.
The Weight Display window will show the word “
CAL
” and the Unit Price window will show
the parameter number.
When a parameter is entered by pressing the [Tare] key, the displays will guide you
through the parameter selected and the options available.
The parameters available are:
F1
CAL
To enter the Calibration
F2
RES
Resolution
selection
F3
CAPA
Select
capacity
F4
0.00 Point
Weight decimal point location
F5
Point 0.00 0.00
Unit Price/Price decimal point
F6
Init ZEro
Initial Zero Range
F7
rE ZEro
Re-Zero range
F8
SCSivE tArE
Successive Tare Enable
F9
A/D counts
Display the A/D counts
F10
roUnd
Rounding off the Total Price
© Adam Equipment Company 2007
17