Polycom 7000 User Manual
NetEngine IAD User Guide
WAN Configuration
81
Configuring
ATM PVCs
You may configure up to 8 ATM PVCs on the IAD. To configure create and
manage PVCs, type
manage PVCs, type
3
on the WAN configuration menu. The IAD displays
the ATM PVC Configuration menu:
Figure 4–36. ATM PVC Configuration Menu
Type the option to perform a task. Proceed to the corresponding section.
u
Adding a New PVC (page
)
u
Modifying an Existing PVC (page
u
Deleting an existing PVC (page
u
Displaying the Current PVCs (page
)
Adding a PVC
To add a PVC, follow these steps:
1. On the ATM PVC Configuration menu, type
1
to select Add New PVC.
2. The IAD displays a prompt for the VPI:
Enter Virtual Port Identifier (VPI):
Type a VPI value between 0 and 255 (default 0) and press Enter.
3. The IAD displays a prompt for the VCI:
Enter Virtual Circuit Identifier (VPI):
Type a VCI value between 32 and 65535 (default is 38 for data, 39 for
voice) and press Enter.
voice) and press Enter.
*****************************************
ATM PVC Config Menu
*****************************************
1. Add New PVC
2. Modify Existing PVC
3. Delete PVC
4. Show Current PVCs
2. Modify Existing PVC
3. Delete PVC
4. Show Current PVCs
NOTE
Before you configure PVCs, you must first set the datalink
protocol to ATM. If option 3 on the WAN Configuration menu
displays Configure DLCIs instead of Configure PVCs, it is
because your datalink protocol is set to Frame Relay instead
of ATM.
protocol to ATM. If option 3 on the WAN Configuration menu
displays Configure DLCIs instead of Configure PVCs, it is
because your datalink protocol is set to Frame Relay instead
of ATM.