Philips AZ1575 Manual

10

• Adjust the POWER slider to the desired sound source: CD,

TUNER or TAPE.

• The set is switched off when the POWER slider is in the

TAPE/OFF position and the buttons on the tape deck are
released.

– The volume, sound settings and tuner presets will be retained in

the set's memory.

1. Turn the VOLUME/ SOUND CONTROL CENTER control

clockwise to increase or anti-clockwise to decrease volume on
the set (or press VOLUME

or 

on the remote control).

™ Display shows the volume level indication 

and a number from

0-32.

2. To adjust the bass, mid and high frequency levels, press DIGITAL

EQUALIZER once or more until the desired option is displayed.
While the option is shown, turn the VOLUME/ SOUND
CONTROL CENTER control to increase or decrease 
(- 5 to + 5 maximum) the desired frequency.

™ VOLUME can also be adjusted in this way with a level range

from 0-32.

3. Press DIGITAL DBB to switch dynamic bass boost on or off.
™ If on, the DIGITAL DBB light goes on.
4. Press INCREDIBLE SURROUND to switch the surround sound

effect on or off.

™ If on, the INCREDIBLE SURROUND light goes on.

• Do not expose the set, batteries, CDs or cassettes to humidity,

rain, sand or excessive heat caused by heating equipment or
direct sunlight.

• To clean the set, use a soft, slightly dampened chamois leather.

Do not use any cleaning agents containing alcohol, ammonia,
benzene or abrasives as these may harm the housing.

• Place the set on a hard and flat surface so that the system does

not tilt. Make sure there is adequate ventilation to prevent the
system from overheating.

• The mechanical parts of the set contain self-lubricating bearings

and must not be oiled or lubricated.

AZ 1575 /17  

page

10

+ 

–

•

•

•

•

•

•

•

•

0

AZ157517  15-12-2000 19:00  Pagina 10