Philips AZ1575 Manual

11

1. Select TUNER source.
™

is displayed briefly and then the radio station frequency

is shown.

2. Press BAND once or more to select your waveband.
3. Press SEARCH

∞ or § (on the remote control, TUNING ∞

or 

§) and release when the frequency in the display starts

running. 

™ The tuner automatically tunes to a station of sufficient 

reception. Display shows  

during automatic tuning.

™ If an FM station is received in stereo, 

is shown.

4. Repeat step 3 if necessary until you find the desired station.
• To tune to a weak station, press SEARCH

∞ or § briefly and

repeatedly until you have found optimal reception.

• For FM, pull out the telescopic antenna.

Incline and turn the antenna. Reduce its length if the signal is
too strong (very close to a transmitter).

• For AM, the set is provided with a built-in antenna so the

telescopic antenna is not needed. Direct the antenna by
turning the whole set.

You can store up to a total of 30 radio stations in the memory. 
1. Tune to your desired station (see Tuning to radio stations).
2. Press PROG to activate programming.
™ Display: 

flashes.

3. Press PRESET

3 or 4 once or more to allocate a number from

1 to 30 to this station.

4. Press PROG again to confirm the setting.
™ Display: 

disappears, the preset number and the frequency

of the preset station are shown.

5. Repeat the above four steps to store other stations.

• You can overwrite a preset station by storing another

frequency in its place.

Press TUNER PRESET

4 or 3 until the desired preset station is

displayed.

AZ 1575 /17  

page

11

AZ157517  15-12-2000 19:00  Pagina 11