Philips mc-320-21t User Manual
MC-320/22-1
16
English
Tape Operation / Recording
Tape playback
1
Select
TAPE source.
2
Press to open the tape door on the top of the
system.
system.
3
Insert a recorded tape and close the tape door.
● Load the tape with the open side downward
and the full spool to the right.
➜ The display shows TAPE briefly. The tape
counter
➜ The display shows TAPE briefly. The tape
counter
0000 display with the
SIDE
A
or
SIDE
B
.
4
Press
to start playback.
5
By pressing
or
, fast winding of tape is
possible in both directions.
● During fast winding, you can monitor the tape
message with the tape counter.
6
To stop the tape, press
STOP
9 .
● To reset the tape counter, press STOP 9 again.
Note:
– The sound source cannot be changed while
recording a tape.
– “NO TAPE” will be shown if no tape inserted.
– The sound source cannot be changed while
recording a tape.
– “NO TAPE” will be shown if no tape inserted.
Switching tape sides
The tape side can be switched manually or
automatically before or during tape playback.
automatically before or during tape playback.
● Press DISPLAY BAND or A/B on remote
control.
➜ The display shows
➜ The display shows
SIDE
A
or
SIDE
B
.
Reverse mode options
● Press PROG / REV repeatedly to select your
option;
PLAY 1 SIDE
PLAY 1 SIDE
: playback or record stops at
the end of the tape.
PLAY A AND B
: both sides are or recorded
played once.
REPEAT A AND B : both sides are played
repeatedly, up to 5 times
each side.
each side.
General information on
recording
recording
● Recording is permissible insofar as copyright or
other rights of third parties are not infringed.
● For recording, use only NORMAL (IEC type I)
tapes on which the tabs have not yet been
broken. This deck is not suited for recording on
METAL (IEC IV) type tapes.
broken. This deck is not suited for recording on
METAL (IEC IV) type tapes.
● The best recording level is set automatically.
Altering the VOLUME, INCREDIBLE
SURROUND, DBB or INTERACTIVE SOUND
controls will not affect the recording in progress.
SURROUND, DBB or INTERACTIVE SOUND
controls will not affect the recording in progress.
● At the very beginning and end of the tape, no
recording will take place during the 7 seconds
when the leader tape passes the recorder heads.
when the leader tape passes the recorder heads.
● To protect a tape from accidental erasure, have
the tape in front of you and break out the left
tab. Recording on this side is no longer possible.
If, however, you wish to record over this side
again, cover the tabs with a piece of adhesive
tape.
tab. Recording on this side is no longer possible.
If, however, you wish to record over this side
again, cover the tabs with a piece of adhesive
tape.