Mercedes Benz 2003 e 320 User Manual

왘

Turn key in the starter switch to 
position 1 or 2.

왘

Hold the end of the hand-held transmit-
ter of the device you wish to train 
approximately 2 to 5 inches (5 cm to 
12 cm) away from the surface of the in-
tegrated remote control located on the 
inside rear view mirror, keeping the in-
dicator lamp in view.

왘

Using both hands, simultaneously push 
the hand-held transmitter button and 
the desired integrated remote control 
button. Do not release the buttons until 
completing the next step.

왘

The indicator lamp on the integrated 
remote control will flash, first slowly 
and then rapidly. The rapid flashing 
lamp indicates successful program-
ming of the new frequency signal.

왘

When the indicator lamp flashes rapid-
ly, release both buttons.

G

When programming a garage door opener, 
the door moves up or down.

When programming or operating the remote 
control make sure there is no possibility of 
anyone being harmed by the moving door.

i

Certain types of garage door openers 
are incompatible with the integrated 
opener. If you should experience diffi-
culties with programming the transmit-
ter, contact your authorized 
Mercedes-Benz Center, or call 
Mercedes-Benz Customer Assistance 
Center (in the USA only) at 
1-800-FOR-MERCedes, or Customer 
Service (in Canada) at 
1-800-387-0100.

i

For operation in the USA only: 
This device complies with Part 15 of 
the FCC Rules. Operation is subject to 
the following two conditions:

(1) This device may not cause harmful 

interference, and

(2) this device must accept any inter-

ference received, including interfer-
ence that may cause undesired 
operation.

Any unauthorized modification to this 
device could void the user’s authority 
to operate the equipment.