Mercedes Benz 2003 e 320 User Manual

왘

To program the remaining two buttons, 
repeat the above steps.

To train a garage door opener (or other roll-
ing code devices) with the rolling code fea-
ture, follow these instructions after 
completing the "Programming" portion of 
this text. (A second person may make the 
following training procedures quicker and 
easier.)

왘

Locate training button on the garage 
door opener motor head unit. 

Exact location and color of the button 
may vary by garage door opener brand. 
If there is difficulty locating the trans-
mitting button, refer to garage door 
opener operator’s manual. 

왘

Press "training" button on the garage 
door opener motor head unit.

The "training light" is activated.

You have 30 seconds time to initiate the 
following step.

왘

Firmly press and release the pro-
grammed integrated remote control 
transmit button. 

왘

Press and release same button a sec-
ond time to complete the training pro-
cess.

Some garage door openers may require 
you to do this procedure a third time to 
complete the training.

왘

Confirm the garage door operation by 
pressing the programmed button on 
the integrated remote control transmit-
ter. 

During programming, your hand-held 
transmitter may automatically stop trans-
mitting. 

왘

Continue to press and hold the inte-
grated remote control transmitter but-
ton (refer to steps two through four in 
the "Programming" portion) while you 
press and re-press ("cycle") your 
hand-held transmitter every two sec-
onds until the frequency signal has 
been learned. 

Upon successful training, the indicator 
lamp will flash slowly and then rapidly 
after several seconds.

i

If, after several attempts, you do not 
successfully program the integrated re-
mote control device to learn the signal 
of the hand-held transmitter, the ga-
rage door opener could be equipped 
with the "rolling code feature".