Runco crystal cx-70dhd User Manual
CX-70DHD Installation/Operation Manual
23
PRE
L
IMINAR
Y
RS-232 Connection: Connect the Display Control output from the DHD Controller to
the RS-232 IN input on the CX-70DHD. Use a cable with an RJ11 plug at the DHD
Controller end and an RJ-45 plug at the CX-70DHD end. (The CX-70DHD accessory kit
includes such a cable.)
the RS-232 IN input on the CX-70DHD. Use a cable with an RJ11 plug at the DHD
Controller end and an RJ-45 plug at the CX-70DHD end. (The CX-70DHD accessory kit
includes such a cable.)
If you make your own cable, it must be wired as shown in Figure 3-5.
Figure 3-5. RS-232 Connection from the DHD Controller to the CX-70DHD
Connecting Source
Components to the DHD
Controller
Components to the DHD
Controller
Connect your video sources to the DHD Controller as shown and described in the
sections that follow.
sections that follow.
HDMI Source Connections: See Figure 3-6.
3
4
5
White/Green*
White/Blue*
3
6
5
Green*
* - CAT5 wire colors, as defined in EIA/TIA-568B
NO CONNECTION
1, 2, 6
1, 2, 4, 7, 8
To/From
DHD
Controller
To/From
CX-70DHD
RJ-11 Male
RJ-45 Male
IN
OUT
RS-232
1
8
6
1
Use the HDMI inputs whenever possible. This ensures the highest
video quality because the signal is carried in the digital domain
throughout the entire signal path, from source component output
into the display.
video quality because the signal is carried in the digital domain
throughout the entire signal path, from source component output
into the display.
You can also connect computers with DVI output to these inputs.
Refer to Supported Timings on page 70 for a list of compatible
input signals.
Refer to Supported Timings on page 70 for a list of compatible
input signals.
Tip
Note