Crestron c2enet-1 c2enet-2 User Manual
Crestron C2ENET-1/-2
2-Series Ethernet Interface Expansion Cards
C2ENET-2
NOTE: When the C2ENET-2 is used as a router, the WAN must be connected to
LAN A and the LAN must be connected to LAN B.
LAN A and the LAN must be connected to LAN B.
As shown in the illustration below, the port(s) contains two light-emitting diodes
(LEDs). The green LED in the upper-left corner of the port(s) illuminates when it is
connected to a working Ethernet. The yellow LED in the upper-right flashes to
indicate Ethernet activity.
(LEDs). The green LED in the upper-left corner of the port(s) illuminates when it is
connected to a working Ethernet. The yellow LED in the upper-right flashes to
indicate Ethernet activity.
C2ENET-1 & C2ENET-2 Faceplates
4.28 in
(10.86 cm)
C2ENET-1 ETHERNET INTERFACE
C2ENET-2 ETHERNET INTERFACE
LAN A
LAN A
LAN B
0.98 in
(2.49 cm)
0.98 in
(2.49 cm)
C2ENET-1/-2 Port Indicators
LINK STATUS
LED (GREEN)
ETHERNET
ACTIVITY
LED (YELLOW)
Industry Compliance
As of the date of manufacture, the C2ENET-1/-2 has been tested and found to
comply with specifications for CE marking and standards per EMC and
Radiocommunications Compliance Labelling (N11785).
comply with specifications for CE marking and standards per EMC and
Radiocommunications Compliance Labelling (N11785).
NOTE: This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Operations & Installation Guide – DOC. 5962B
2-Series Ethernet Interface Expansion Cards: C2ENET-1 & C2ENET-2
• 3