Crestron cnx-6pak User Manual
Source Selection and Control
src1
src2
src3
src4
src5
src6
• Source Selection Buttons (src1 through src6): These buttons select
the source for listening/control in the given room.
A solid LED indicates that the source is selected and can be controlled.
A blinking LED indicates that a source is in use by another room and
cannot be controlled Refer to "Priority Override" on page 16 for an
exception.
If a source is selected and has a solid LED, pressing the button again
issues the NEXT1 command to that device.
A solid LED indicates that the source is selected and can be controlled.
A blinking LED indicates that a source is in use by another room and
cannot be controlled Refer to "Priority Override" on page 16 for an
exception.
If a source is selected and has a solid LED, pressing the button again
issues the NEXT1 command to that device.
• Previous/Next Buttons: These buttons control the selected source
(unless the source LED is blinking, refer to "Priority Override" on page
16).
Press and release the Prev/Next buttons to send the PREV1/NEXT1
commands to the selected source. Press and hold the Prev/Next buttons
to send the PREV2/NEXT2 commands to the selected source.
To change the NEXT and PREV commands for a given device, refer to
the "Audio Properties" subsection of "Step 2: Add Sources" on page 9
for details.
16).
Press and release the Prev/Next buttons to send the PREV1/NEXT1
commands to the selected source. Press and hold the Prev/Next buttons
to send the PREV2/NEXT2 commands to the selected source.
To change the NEXT and PREV commands for a given device, refer to
the "Audio Properties" subsection of "Step 2: Add Sources" on page 9
for details.
Priority Override
The source button LEDs blink if another room has control priority over the selected
source. This means that this room can listen to the source, but cannot control it.
source. This means that this room can listen to the source, but cannot control it.
If another room has control over the current source, control can be taken from the
other room by pressing and holding the source button for about two seconds.
other room by pressing and holding the source button for about two seconds.
Audio Configuration
The function keypads provide additional functionality for configuring both the room
and source settings. Room settings include properties such as bass, treble, and
balance, and only affect the room from which they are adjusted. Source settings are
the input gain on the CNX-PAD8 for each source, allowing the volume level of each
source to be normalized relative to one another. Adjusting the input gain for a source
affects the volume of that source in all rooms.
and source settings. Room settings include properties such as bass, treble, and
balance, and only affect the room from which they are adjusted. Source settings are
the input gain on the CNX-PAD8 for each source, allowing the volume level of each
source to be normalized relative to one another. Adjusting the input gain for a source
affects the volume of that source in all rooms.
Under normal operation, the keypads operate as described in "System Operation" on
page 15. In order to adjust the room or source settings, the appropriate mode, as
described in the following subsections, must be entered.
page 15. In order to adjust the room or source settings, the appropriate mode, as
described in the following subsections, must be entered.
16
• Six-Zone Audio Package: CNX-AUDIO-6PAK
Operations & Installation Guide - DOC. 8169