Compustar p1wamr User Manual

Advanced System Functions

The following section reviews advanced system functions. Many of these functions require multiple steps
or additional programming by your local authorized CompuStar dealer to be active.

Drive Lock/Ignition Controlled Door Locks

Tap buttons

simultaneously for 0.5 seconds to turn drive lock on and off

(also known as ignition controlled door locks). The vehicle’s parking lights will flash once and/or siren
chirp once to confirm drive lock is off. The vehicle’s parking lights will flash twice and/or siren chirp twice
to confirm drive lock is on.

IMPORTANT: Drive lock mode requires that the dealer turn on Option 1-9. Drive lock has two settings;

Default 1: Off
Option 2: Locks the doors when the ignition is on and after the brake is depressed.
Option 3: Locks the doors when the RPM’s have reached two times that of idle speed (this setting
requires that a tachometer wire is connected) This feature may require additional labor and is not
available on the P1W900FM-A, P1WSH-A, or P1WAM-A systems.

With both settings, the doors will unlock when the ignition is turned off. If using this feature on a manual
transmission vehicle, the doors will unlock upon setting the emergency / parking brake.

Turbo Timer Mode

The built-in turbo timer keeps the vehicles engine running for either 1, 2, or 4 minutes
(programmable from dealer with Option 2-2) after the vehicle key has been removed from the
ignition. This feature will keep oil running through the turbo system to allow for appropriate

cooling time. Tap buttons

simultaneously for 0.5 seconds to turn on or off

turbo mode. The vehicle’s parking lights will flash once and/or siren chirp once to confirm turbo mode is
on. The vehicle’s parking lights will flash twice and/or siren chirp twice to confirm turbo mode is off.

IMPORTANT: To utilize this feature, the emergency / parking brake wire must be connected to the
CompuStar system. Consult your local authorized CompuStar dealer for installation.

Car Mode (Multiple Vehicle Control)

The P1WSHR (US Style) remotes have the ability to operate two vehicles using only one

remote. Hold buttons

simultaneously for 2.5 seconds to turn on or off 2

car

mode. The remote LED will flash slowly to confirm that 2

car mode is activated.

IMPORTANT: 2

car mode requires the remote to be programmed to a 2

vehicle that is equipped with

either a (US Style) P1WSH-AS, P1WSH-A or P1WSH-S.

Secure Valet Switch

The optional Secure Valet Switch prevents the alarm from being put into valet mode through cycling the
ignition on/off five times. The Secure Valet Switch is more secure than traditional toggle / valet switches
because it requires a two digit code. IMPORTANT: The first two digits of the RPS unlock/disarm pass
code will be the default pass code for the secure valet – you do not need to program them
independently. If you are not using the RPS unlock, following the below procedures to program your
secure valet pass code;