Honeywell HD3MDIPX User Manual

HD3MDIP/X Network Camera Reference Guide

Document 800-04132V1 Rev A

01/10

Flush Mount (with or

without 4S box)

1. Use the screws (supplied) to

connect the adapter plate directly
to the ceiling or wall.
Or
Use your own screws to connect
the adapter plate to the 4S box (not
supplied) which is attached to the
ceiling or wall.

2. Connect the wires (see

Connecting

the Wires

on page

3. Secure the camera assembly to the

adapter plate by twisting clockwise
until it clicks securely in place.

4. Adjust the camera’s field of view

(see

Adjusting the Camera FOV

(Field of View)

on page

5. Install the turret by clicking it into

place.

6. Install the bubble by placing it on

the camera with the tabs to the left
of the slots, then turning it clockwise until the tabs click securely into place.

Restore Factory Defaults

Your network camera has a Factory Reset switch located inside the camera (see

Figure 2-6

page 22

). This switch restores your camera settings and passwords to their default

settings. Press and hold the Reset switch for three seconds. This will reset the
factory-configured parameters such as the compression settings, the camera tamper
detection settings, and the Video Motion Detection settings. It will not impact network IP
address configurations.

Adjusting the Camera FOV (Field of View)

To adjust the HD3MDIP/X camera:
1. Apply power to the camera and watch the video on a connected local video monitor

(see

Figure 2-7

page 22

to connect a local video monitor).

2. Loosen the setscrew that locks the gimbal assembly in place (see

Figure 2-8

) to

adjust the horizontal rotation.

Bubble

Adapter plate