Curtis tc590 User Manual
If after pressing the Talk button, you receive three “beeps” and no dial tone, check the
following:
1. BASE UNIT is plugged into a power source.
2. If you had a power failure or had unplugged the BASE UNIT, replace the
2. If you had a power failure or had unplugged the BASE UNIT, replace the
HANDSET on the BASE UNIT for 2 to 5 seconds to reset the system.
NOTE:
If none of the telephones in the house are working, disconnect one set at a time to
verify that none of the phones are causing the problem. If you still have a problem
after doing this, and your telephone still does not work, please contact your local
phone company.
verify that none of the phones are causing the problem. If you still have a problem
after doing this, and your telephone still does not work, please contact your local
phone company.
Can not register the HANDSET, when place HANDSET to BASE UNIT not a long beep
heard but the triple beep, check as following:.
1. HANDSET is more than 5.
2. Already has a HANDSET with ID=5, and wish register a new one. In this situation,
2. Already has a HANDSET with ID=5, and wish register a new one. In this situation,
you should reset the BASE UNIT.
3. reset
the
BASE UNIT: In standby mode, plug the T/P switch to the “P” position
and push and hold the PAGE button on the BASE UNIT 8 -10 seconds, the
CHAGRER LED will fast flash 1 second . After reset the BASE UNIT, place the
each HANDSET to the BASE UNIT for 2 to 5 second for register(see page 29 for
detail).
CHAGRER LED will fast flash 1 second . After reset the BASE UNIT, place the
each HANDSET to the BASE UNIT for 2 to 5 second for register(see page 29 for
detail).
33
Problem Solving