Runco plasmawall xp-50dhd, xp-50dhdxa, xp-65dhd, xp-65dhdxa, xp-103dhd User Manual
8
PlasmaWall XP Series Owner’s Operating Manual
PRE
L
IMINAR
Y
1.
SLOT 1
Not used.
2.
SLOT 2 (DVI-D or Dual HDMI input)
HDCP-compliant digital video input(s). Connect the HDMI output from the DHD
Controller to this input.
Controller to this input.
If SLOT 2 is equipped with an Dual HDMI input board, connect the HDMI output
from the DHD Controller to input “A” on this board.
If SLOT 2 is equipped with a DVI-D input board, the audio input is not used. Connect
the audio outputs from your sources to an external audio receiver.)
3.
SLOT 3
Not used.
4.
PC IN
Not used.
5.
RS-232C (9-pin, male D-Sub)
Connect the RS-232 OUT port on the DHD Controller to this input.
6.
POWER INPUT
Connect the PlasmaWall to AC power here.
2.2
DHD Controller Front
Panel
DHD Controller Front
Panel
Figure 2-5 shows the controls and indicators on the DHD Controller front panel; the
paragraphs that follow describe them.
paragraphs that follow describe them.
Figure 2-5. DHD Controller Front Panel
1.
RUNCO ICON
Lights red to indicate that the DHD Controller is in standby mode; lights blue to
indicate that the unit is on.
indicate that the unit is on.
2.
POWER BUTTON
Press once to toggle from standby mode to on mode. Press it again to return to
standby mode. For a discrete on or off command, you can use the direct access
buttons on the remote control.
standby mode. For a discrete on or off command, you can use the direct access
buttons on the remote control.
3.
IR SENSOR
Receives IR commands from the remote.
2
3
1
4
5
6
7
8
9
10