Honeywell equip hd3mdih User Manual

Document 800-07361 Rev A

25

12/10

1. Use the screws (not supplied) to 

connect the adapter plate directly 
to the ceiling or wall. 
Or
Use your own screws to connect 
the adapter plate to the 4S box (not 
supplied) which is attached to the 
ceiling or wall. 

You must use screws that are 
able to support at least three 
times the weight 
of the camera. 

2. Connect the wires (see 

).

3. Secure the camera assembly to the 

adapter plate by twisting clockwise 
until it clicks securely in place.

4. Adjust the camera’s field of view 

(see 

5. Install the turret by clicking it into place.
6. Install the dome bubble by placing it on the camera with the tabs to the left of the 

slots, then turning it clockwise until the tabs click securely into place.

Your HD3MDIH/X camera has a Factory Reset switch located inside the camera (see 

 on 

). This switch restores your camera settings and passwords to their 

default settings. Press and hold the Reset switch for three seconds. This will reset the 
factory-configured parameters such as the compression settings, the camera tamper 
detection settings, and the Video Motion Detection settings. This will not impact network IP 
address configurations. 

To adjust your HD3MDIH/X camera:
1. Verify that power is supplied to your camera.

Dome bubble

Adapter plate

Camera 
assembly

Turret

Installation with 4S box shown

4S box (not supplied and optional) 

Screws
(supplied)

Screw caps