Lifescan surestep pro User Manual
23
If the white pad becomes completely saturated,
you have applied too much control solution.
Repeat the application with a new test strip.
you have applied too much control solution.
Repeat the application with a new test strip.
• Check the confirmation dot on the back of
the test strip to verify it has turned
completely blue, indicating an adequate
amount of control was applied.
completely blue, indicating an adequate
amount of control was applied.
If white patches or streaks are visible, you have
not applied enough control solution. Repeat
the application with a new test strip.
not applied enough control solution. Repeat
the application with a new test strip.
• Wipe the control solution vial tip with a
lint-free cloth or tissue before replacing the
cap.
cap.
Firmly insert the test strip all the way into the
test strip holder until it stops (the
confirmation dot should be facing down).
test strip holder until it stops (the
confirmation dot should be facing down).
9
BU.book Page 23 Monday, October 28, 2002 11:14 PM