bobcat 2200d User Manual
Bobcat 2200 Diesel Vehicle
Operation & Maintenance Manual
Operation & Maintenance Manual
30
Figure 18 Remove Engine Oil Filter
Figure 19 Coat Rubber Seal
Figure 20 Add Engine Oil
4. Use a clean, lint-free rag to wipe the oil filter port
flange surface clean where the oil filter gasket seats.
5. To help seal the new oil filter to the oil port flange,
apply a light coat of white lithium NLGI Number 2
grease (Dow Corning
®
BR2-Plus or equivalent) or
new engine oil to the rubber seal around the outside
surface of the filter before attaching it to the oil filter
port [Figure 19]. Install the new oil filter (gas:
102443401 CC, diesel: 102628401 CC) onto the
engine oil filter port. See following NOTE.
surface of the filter before attaching it to the oil filter
port [Figure 19]. Install the new oil filter (gas:
102443401 CC, diesel: 102628401 CC) onto the
engine oil filter port. See following NOTE.
NOTE: Use only Bobcat oil filters designed for your
engine.
6. Tighten the oil filter by hand 2/3 turn after gasket
contact. Do not use a band wrench or channel lock
pliers.
pliers.
Engine Oil Filling
1. Add engine oil; use a funnel or pour spout to direct
the oil into the opening [Figure 20]. With filter
change, the engine requires 2,8 L. Refer to oil
viscosity guidelines for selection of oil grade
[Figure 21]. See following CAUTION.
change, the engine requires 2,8 L. Refer to oil
viscosity guidelines for selection of oil grade
[Figure 21]. See following CAUTION.
CAUTION
CAUTION
•
Do not exceed recommended oil capacity. Doing
so will decrease engine performance or result in
damage to the engine.
so will decrease engine performance or result in
damage to the engine.
2. Connect the battery cables, positive (+) cable first,
and tighten terminals to 27,1 Nm. Coat terminals with
Battery Terminal Protector Spray (1014305 CC).
Battery Terminal Protector Spray (1014305 CC).
3. With the Forward/Reverse handle in the NEUTRAL
position, start and run the engine for a few minutes.
Observe both the drain plug and the oil filter from
under the vehicle and watch for oil leaks. If a leak is
detected, check the tightness of the oil filter and drain
plug. Tighten, repair, and/or replace components as
necessary.
Observe both the drain plug and the oil filter from
under the vehicle and watch for oil leaks. If a leak is
detected, check the tightness of the oil filter and drain
plug. Tighten, repair, and/or replace components as
necessary.
NOTE: Wait five minutes after turning off the engine
before removing the dipstick.
4. Remove the dipstick and check the engine oil as a
final step. Replace the dipstick.
USED OIL FILTER
OIL DRIP GUARD
DRAIN PAN