Konica Minolta pi2001e um 110 User Manual
6
Control Panel Operations (PC Print Mode)
6-6
Pi2001e
Using the Bypass Tray
Use the procedure described below to print onto paper that is fed (one
sheet at a time) from the bypass tray.
sheet at a time) from the bypass tray.
1
On your computer, display the “Setup” tab of the printer driver, and
then specify “Bypass” for the
then specify “Bypass” for the
Paper Source
2
Execute the print operation from your computer.
3
When the message “LOAD PAPER”
appears on the copier’s display,
load paper onto the bypass tray.
appears on the copier’s display,
load paper onto the bypass tray.
H
This causes the print operation
to be performed using the paper
from the bypass tray.
to be performed using the paper
from the bypass tray.
4
Repeat step 3 as many times as necessary until printing of the
document is complete.
document is complete.
Note
Be sure to execute the print operation from the computer first, and then
place the paper onto the bypass tray. If there is already paper on the
bypass tray when you execute the print operation, remove it, and then
place it again onto the bypass tray.
Be sure to execute the print operation from the computer first, and then
place the paper onto the bypass tray. If there is already paper on the
bypass tray when you execute the print operation, remove it, and then
place it again onto the bypass tray.
Load the paper into the manual bypass tray one sheet at a time.
If the multiple bypass tray (optional) is installed, it can used in the
same way as any other paper tray since the multiple bypass tray can
hold 100 sheets of paper.
same way as any other paper tray since the multiple bypass tray can
hold 100 sheets of paper.
The multiple bypass tray can be loaded with a maximum of 10
envelopes, 20 OHP transparencies, 20 postcards, 20 label sheets, or
100 sheets of plain paper.
envelopes, 20 OHP transparencies, 20 postcards, 20 label sheets, or
100 sheets of plain paper.