Fagor nc-200 pb Installation Instruction

This NC can be connected to an AC voltage anywhere between 100V AC and 264 V AC
±10% at a frequency between 45 Hz and 400 Hz. Between 120Vdc and 300Vdc without
having to select it depending on the country where they are installed thanks to their
universal power supply.

Always mount it vertically so its keyboard is within operator's reach and its digits are
easily visible (at operator's eye level).

Connect all metallic parts to a common point on the machine tool and it to the general
ground point. Use cables of enough gage (no thinner than 8 mm

2

).

Turning the unit ON
The unit is turned on by actuating on the power switch of the rear panel
This NC runs a self-test and shows on the LCD display the text: “Fagor NC-200PB, Press

  and the 

  and 

 displays show "Fagor dro" if everything is OK and the error

number if otherwise. See the appendix at the end of this manual.

If you press 

   this NC turns off the displays while maintaining the power supply to

the feedback systems and goes on reading the position of the axes at all times. This is
not the case when the equipment is switched off by means of the switch on its rear
panel.

To reset the displays, just press this  basta 

   again, as long as this NC is getting

voltage (plugged in and with the switch on the rear panel on).

Notes:
- Before powering this NC down with the switch on the rear panel or disconnecting it

from mains, it is a good idea to press the 

  

 key in order to store the current

position of the axes permanently.

- If the unit is powered down with its rear panel switch or there is a power outage without

previously having pressed 

 

, this NC will keep the last position of the axes for at

least 30 minutes.

- The unit will display ERROR 2 when powered back up if the position reading was lost

when turned off while the axes were moving or after the accidental backup period has

expired without having saved the current position by previously pressing 

 

 

.