Fagor nc-200 pb Installation Instruction
Page: 34 - Installation Manual - NC-200 PB
3.1 PARAMETER SETTING
Machine parameters PAR50, PAR51 and PAR90 enable special features of this NC.
The user may access them directly.
The user may access them directly.
In initial mode, press
[parameter number] .
The rest can only be accessed by installers and technicians.
Press and hold
for at least 2 seconds, when the displays start blinking,
press
.
Key in the access code: 060496 to access the general parameters.
Once on the menu, to access a particular parameter, press:
[Parameter number]
The LCD display will shows the parameter number and a short description.
. If it is a general parameter, its value is only shown on the first display.
. If it is an axis parameter, each axis display will show its current value.
In this case, select the axis by pressing its key (
or
) and key in its
new value.
- To go to the next parameter saving the changes:
Press
or
to go to the next one.
To return to the previous one, press
- Pressing the key of the other axis (
or
) saves the value of the previous
axis and it goes on to edit the new selected axis.
- Pressing
will quit the parameter editing mode.
- If while changing the value of a parameter,
is pressed, the unit will ignore
the new value and will assume the previous one.