Fagor nc-200 pb Installation Instruction

Absolute value set on each axis at the end of the home search.

On press brakes, it coincides with (see section 2.4):

On the X axis: the distance from the center of the die to the support

side of the X carriage.

On the Y axis: The distance between the support sides of the punch

and the die.

Factory setting: 0.

This value will be in mm or inches depending on whether the INCH
LED is off or on.

To set the minimum axis travel limit.

Possible values: within ±99999.999

This value will be in mm or inches  depending on whether the INCH
LED is off or on.

If PAR08(2)=1 (limit alarms ON), when the axis exceeds this
distance, the corresponding axis display starts blinking until it is
moved back into the work zone.

To set the maximum axis travel limit.

Possible values: within ±99999.999

This value will be in mm or inches  depending on whether the INCH
LED is off or on.

If PAR08(2)=1 (limit alarms ON), when the axis exceeds this
distance, the corresponding axis display starts blinking until it is
moved back into the work zone.

It sets how the machine reference search (I0) will be carried out .

Digit

8, 7, 6, 5

Not being used at this time. They must be set to "0".

4

If =1, mandatory home search on power-up.

3

If =1, The whole home search is carried out at slow speed.

2

It does not use a home switch.

Home search begins slowly in the negative direction. It ends when
detecting the 1st marker pulse (home signal) of the encoder.