Fagor nc-200 pb Installation Instruction

5

Axis units: 0 = mm, 1 = inches

These units refer to the feedback and not to the display which may

be changed with the 

 key..

4

Not being used at this time. It must be set to "0"

3

Not being used at this time. It must be set to "0"

2

Type of feedback signals (0 = TTL)

This bit must be set to "0". A value of "1" will be ignored.

1

Counting direction (0 = normal, 1 = reverse)

Regulation for press brakes:

X axis retraction in the positive direction.
Ram up movement in the positive direction.

If an axis count increases or decreases in the opposite direction to the
one desired, change the value of this digit. It conditions the setting of
the sign bit PAR46(2) and the sign of the analog voltage.

Feedback resolution, independent for each axis,

Possible values:

from 0.0001 mm to 1 mm.

From 0.000001 to 0.03937 inch

factory setting:

0.0050 (mm).

TTL multiplying factor (subdivision). Independent for each axis.

Options: x4, x2, x1 and x0.5.

The selection of these values rotates by pressing 

The factory setting is: x4 and it is the one used for FAGOR scales.

When using an encoder, its number of pulses should be calculated
according to the leadscrew pitch, the desired resolution and the
multiplying factor to be applied as per the formula:

Encoder (lines/turn) =

Leadscrew pitch (mm/turn)

Resolution (mm/pulse) x F

Where "xF" would be the multiplying factor to be applied.