Kenwood VR-9080 User Manual

After completing "Setting up the speakers automatically (AUTO SETUP)",
the most suitable equalizer curve for the frequency characteristics of
your speakers and the room will be set for each ACTIVE EQ mode.

1 For the remote control unit, press the RCV MODE key to switch

2 Press the ACTIVE EQ key for the following selections;

1 ACTIVE EQ OFF

: The ACTIVE EQ function is turned OFF.

2 ACTIVE EQ FLAT*

: Frequency response from speakers are

flat.

3 ACTIVE EQ MUSIC : Effective when listening to music.
4 ACTIVE EQ CINEMA : Effective when watching movie.
5 ACTIVE EQ GAME

: Effective when playing video game.

*It can be selected after AUTO SETUP is carried out.

• If THX key is pressed, ACTIVE EQ mode is changed to "ACTIVE EQ

FLAT" automatically.
After that you can change the ACTIVE EQ mode by pressing the
ACTIVE EQ key.

• ACTIVE EQ function will not be available when in REC mode.

If the input level of an analog source signal is too high, the CLIP indicator
will blink. Adjust the input level.

1 Use the INPUT SELECTOR key or Input Selector keys to select the

source of which the input level you want to adjust.
• You can store a separate input level for each input source.

2 For the remote control unit, press the RCV MODE key to switch

3 Press the SOUND key and 5/∞ keys or MULTI @/# keys repeat-

4 Use the MULTI CONTROL knob or MULTI %/fi keys to adjust the

• The adjustment mode is displayed for approximately 20 seconds.
• The input level can be adjusted to any one of three settings: 0dB,

-3dB, and -6dB. (The initial setting is 0dB.)

5 Press the SOUND key to accept the setting.

*5557/27-32/EN

05.7.16, 1:26 PM

28