Kenwood VR-9080 User Manual

You can adjust the sound quality when the receiver is in the PCM stereo
and analog stereo mode, and both THX and Virtual mode are off.

1 For the remote control unit, press the RCV MODE key to switch

2 Press the TONE key to select the TONE mode.

3 Use the MULTI CONTROL knob or MULTI %/fi keys to select

4 When in TONE ON selection, press the TONE key for the follow-

: Select this to adjust the low frequency range.

TREBLE : Select this to adjust the high frequency range.

5 Use the MULTI CONTROL knob or MULTI %/fi keys to adjust the

• The bass and treble levels are adjustable from -10 to +10 in 2 step

increments.

• The adjustment item is displayed for approximately 20 seconds.
• This function is available only for speakers connected to FRONT A

terminals.

You can adjust the Loudness function which controls the low volume
settings to maintain the music's richness. This setting can be made
when the receiver is in the PCM stereo and analog stereo mode, and
both THX and Virtual mode are off.

• This function is available only for speakers connected to FRONT A

terminals.

This setting can be made when the receiver is in the PCM stereo and
analog stereo mode, and  both THX and Virtual mode are off.

Press the BASS BOOST key.
• Press the key once to select the maximum (+10) low frequency

emphasis setting.

• This key does not function when the receiver is in the sound quality

or ambience effects adjustment mode.

• This function is available only for speakers connected to FRONT A

terminals.

The MUTE key lets you mute the sound of the speakers.

Blinks

Press the MUTE key again so that the “MUTE” indicator goes off.
• MUTE ON can also be deactivated by turning the VOLUME CON-

TROL knob or pressing VOLUME 

%/fi keys.

1 Connect headphones to the PHONES jack.

• The sounds from all speakers are cut off.

2 Use the VOLUME CONTROL knob or VOLUME %/fi keys to

*5557/27-32/EN

05.7.16, 1:26 PM

29