ZyXEL Communications zywall idp 10 User Manual
ZyWALL IDP 10 Quick Start Guide
8
Table 1 Front Panel Ports
LABEL DESCRIPTION
CONSOLE
Use this port if you want to configure the ZyWALL IDP using the command-line
interface. See your User’s Guide for details on commands.
interface. See your User’s Guide for details on commands.
Connect the 9-pin male end of the console cable to the console port of the ZyWALL
IDP and the other end to a serial port (COM1, COM2 or other COM port) on your
computer. Your computer should have a terminal emulation communications
program (such as HyperTerminal) set to VT100 terminal emulation, no parity, 8 data
bits, 1 stop bit, no flow control and 9600 bps port speed.
IDP and the other end to a serial port (COM1, COM2 or other COM port) on your
computer. Your computer should have a terminal emulation communications
program (such as HyperTerminal) set to VT100 terminal emulation, no parity, 8 data
bits, 1 stop bit, no flow control and 9600 bps port speed.
4.2 Rear Panel
Figure 4 Rear Panel Power Connection
Table 2 Rear Panel Power Connection
LABEL DESCRIPTION
POWER 5V,
4A
4A
Connect the included power adaptor to this power socket.