ZyXEL Communications zywall idp 10 User Manual
ZyWALL IDP 10 Quick Start Guide
9
Table 2 Rear Panel Power Connection
LABEL DESCRIPTION
WARNING: Using an incorrect power adapter will damage your device!
After you’ve made the connections, use the power cord to connect the power adaptor to a power
source and look at the front panel LEDs.
source and look at the front panel LEDs.
4.3 The Front Panel LEDs
Figure 5 Front Panel LEDs
The PWR LED turns on when you first connect the power. The SYS LED blinks while performing
system testing and then stays on if the testing is successful. The WAN, LAN and MGMT LEDs turn on
if the corresponding connections are properly made. Refer to the following table for more detailed LED
descriptions.
system testing and then stays on if the testing is successful. The WAN, LAN and MGMT LEDs turn on
if the corresponding connections are properly made. Refer to the following table for more detailed LED
descriptions.
Table 3 Front Panel LEDs
LED COLOR STATUS
DESCRIPTION
Off
The ZyWALL IDP is turned off.
Green
On
The ZyWALL IDP is turned on.
PWR
Red
On
The power to the ZyWALL IDP is too low.
Off
The ZyWALL IDP is not ready or has failed.
On
The ZyWALL IDP is ready and running.
SYS Green
Blinking
The ZyWALL IDP is restarting.
Off
The WAN connection is not ready, or has failed.
WAN
10/100
10/100
Green
On
The ZyWALL IDP has a successful 10Mbps WAN
connection.
connection.