ZyXEL Communications ZyWALL 100 User Manual
ZyWALL 100
10
WAN IP Address Assignment
Select Get automatically from ISP if
your ISP did not assign you a fixed IP
address. Select Use fixed IP address
if the ISP assigned a fixed IP address
and then enter your IP address and
subnet mask in the next two fields.
Enter the gateway IP address in this
field (if provided) when you select Use
Fixed IP Address.
Select Get automatically from ISP if
your ISP did not assign you a fixed IP
address. Select Use fixed IP address
if the ISP assigned a fixed IP address
and then enter your IP address and
subnet mask in the next two fields.
Enter the gateway IP address in this
field (if provided) when you select Use
Fixed IP Address.
DNS Server Assignment
Select Get automatically from ISP if
your ISP does not give you DNS
server addresses.
If you selected the Use fixed IP
address – Primary/Secondary DNS
Server option, enter the provided
DNS addresses in these fields.
Select Get automatically from ISP if
your ISP does not give you DNS
server addresses.
If you selected the Use fixed IP
address – Primary/Secondary DNS
Server option, enter the provided
DNS addresses in these fields.
WAN MAC Address
Select Factory Default to use the factory assigned default MAC address. Alternatively, select Spoof this Computer's MAC
address - IP Address and enter the IP address of the computer on the LAN whose MAC address you are cloning.
Select Factory Default to use the factory assigned default MAC address. Alternatively, select Spoof this Computer's MAC
address - IP Address and enter the IP address of the computer on the LAN whose MAC address you are cloning.
Test Your Internet Connection
Launch your web browser and navigate to
www.zyxel.com
. You don’t need a dial-up program such as Dial
Up Networking. Internet access is just the beginning. Refer to the User’s Guide for more detailed
information on the complete range of ZyWALL features.
information on the complete range of ZyWALL features.
Troubleshooting
PROBLEM CORRECTIVE
ACTION
None of the
LEDs turn on
when you turn
on the ZyWALL.
LEDs turn on
when you turn
on the ZyWALL.
Make sure that you have the correct power adapter connected to the ZyWALL and plugged in to an
appropriate power source. Check all cable connections.
appropriate power source. Check all cable connections.
If the LEDs still do not turn on, you may have a hardware problem. In this case, you should contact
your local vendor.
your local vendor.
Cannot access
the ZyWALL
from the LAN.
the ZyWALL
from the LAN.
Check the cable connection between the ZyWALL and your computer or hub. Refer to the Rear Panel
section for details.
section for details.
Ping the ZyWALL from a LAN computer. Make sure your computer Ethernet card is installed and
functioning properly.
functioning properly.
Cannot ping any
computer on the
LAN.
computer on the
LAN.
If the 10/100M LAN LEDs are off, check the cable connections between the ZyWALL and your LAN
computers.
computers.
Verify that the IP address and subnet mask of the ZyWALL and the LAN computers are in the same
IP address range.
IP address range.