Kenwood TK-3302U User Manual

9

1  Turn the Power switch/ Volume control clockwise to switch 

the transceiver power ON.

•  A beep sounds if enabled by your dealer.

2  Press the key programmed with the Monitor or Squelch Off 

function to hear background noise, then rotate the 

switch

/ Volume control to adjust the volume.

3  Rotate the Channel selector to select your desired channel.

•  When you receive an appropriate signal, you will hear audio 

from the speaker.

4  To make a call, press and hold the PTT switch, then speak 

into the microphone using your normal speaking voice.

•  Hold the microphone approximately .5 inches (3 to 4 cm) from 

your lips.

5  Release the PTT switch to receive.

Note:  When the battery pack voltage becomes too low, transmission 

will stop and an alert tone will sound.

Lights red

Transmitting

Lights green

Receiving a call

Blinks red

Battery power is low while transmitting

Blinks green

Scanning

Blinks orange

Receiving an encoded call (QT/DQT, 

FleetSync signaling, etc.)

Blinks red/orange

The selected channel has not been 

programmed and cannot be used.