Konica Minolta kn-304-qsg ej User Manual
KN-304 Quick Configuration Guide
11
English
● MAP Setup
Two programs consisting of “MAP Setup” and “MAP” are installed when the MAP setup program is run. MAP
setup is a program for setting up an environment for detecting KN-304. Run the MAP setup program first.
Select [Start], [Program], [Map] and finally [MAP Setup] to start up the MAP setup program.
In MAP setup, the protocol to be used by the KN-304 detected when starting MAP and the maximum number of
IP hops are designated. Check [Search for IPX based Printer] when detecting KN-304 using IPX, or check
[Search for IP based Printer] to detect KN-304 using IP.
In the case of using IP for the network protocol, designate the [Max. Hops for IP Search]. Valid settings for [Max.
Hops for IP Search] are from 0 to 15, and the default (initial value) setting is 2. In the case of designating a
value of 0, only the segment belonging to the computer that started up MAP is searched. In the case of setting
a value of 2, all networks are searched that can be accessed by going through up to 2 routers. It should be
noted that as the designated value becomes larger, the amount of traffic encountered becomes correspond-
ingly larger.
● Web Utility
The procedure for using the web utility is as described below.
Select [Start], [Program], [Map] and then [MAP] to start up the MAP program.
When MAP is started, it searches for a KN-304 on the network according to the contents of the MAP
settings. When a KN-304 is detected, the web browser designated as the standard browser is
started up and a list of available KN-304 printers is displayed.
Select the printer to be set up.
The main menu of the KN-304 selected is displayed.
•
When displayed in the desired language, click on "Network Setting" and proceed to step 4.
•
When not displayed in the desired language, proceed to step 3.
Select the language.
[Selection Procedure]
1. Add /local to the URL of the web browser on the main menu and then press Enter.
Example: http://10.12.10.119/local
The language selection menu is displayed.
2. Click on the language to be used.
The selected language is displayed.
3. Click on [home].
After the "Network Management Menu" is displayed, click on the items to be set to make the neces-
sary settings.
System
Protocols
Others
Reset
Setup NetWare
Test Printer
Factory Defaults
Setup TCP/IP
Configure Status Page
Unit Status
Setup IPP
Printer Status
Network Address
Change Password