Nortel Networks 5399 User Manual
Nortel Networks 5399 Access Switch Hardware Installation Guide
Chapter 4
Troubleshooting Procedures
4-10
Table 4-5. Errors from Last Open Request
Correcting Remote Access Concentrator
Parameters
Parameters
The following parameters must accurately reflect both the Remote Access
Concentrator and the network environment in which it operates.
Concentrator and the network environment in which it operates.
Verify the Remote Access Concentrator’s IP address using the addr
command. If your network configuration does not support the factory
defaults, verify the following parameters using the addr command:
command. If your network configuration does not support the factory
defaults, verify the following parameters using the addr command:
•
The broadcast address.
•
The subnet mask.
•
The load/dump gateway address (which must be specified if
the preferred load server host is located on another network
or subnet).
the preferred load server host is located on another network
or subnet).
Error
Description
ARP errors
Address Resolution Protocol (ARP) errors indicate that
the Remote Access Concentrator is configured to boot
from a specified host, but the host would not transmit its
Ethernet address to the Remote Access Concentrator.
Possibly, the Remote Access Concentrator configuration
includes the wrong IP encapsulation, or the subnet mask
is misconfigured on the host or the Remote Access
Concentrator.
the Remote Access Concentrator is configured to boot
from a specified host, but the host would not transmit its
Ethernet address to the Remote Access Concentrator.
Possibly, the Remote Access Concentrator configuration
includes the wrong IP encapsulation, or the subnet mask
is misconfigured on the host or the Remote Access
Concentrator.
ERPC layer
errors
errors
See
.
Aborts rx’d
The host’s BFS transmitted an abort in response to the
Remote Access Concentrator’s Open Request. This often
means that the requested file does not exist on that
server, or that it is installed in the wrong directory or
with the wrong permissions. Run erpcd –D on the host
to obtain more information.
Remote Access Concentrator’s Open Request. This often
means that the requested file does not exist on that
server, or that it is installed in the wrong directory or
with the wrong permissions. Run erpcd –D on the host
to obtain more information.